Skoda 6VE 061 197 Instrucciones De Montaje página 12

Fig. 4
EN
› Moisten the surface of the rear bumper with a sufficient amount of soapy water solution that
does not contain any additional agents (the recommended mixing ratio is 25 ml of detergent
to 10 litres of water, i.e. 0.25% solution concentration).
Fig. 5
› Moisten your fingers using the prepared solution. Remove the masking paper from the foil
and dispose of it as sorted waste. Moisten the underside of the foil using the prepared soapy
water solution.
Figs. 6A, 6B
› Place the foil on the bumper as shown.
› The mark on the film indicates its center; for distance "a", see the figure for given vehicle type.
Caution! Ensure that it is correctly positioned. The center of the film
must be aligned with the tailgate lock latch (cover cap). The front edge
of the film must follow the end of radius of the bumper surface at the
defined distance.
Fig. 7
› Moisten the surface of the foil using the prepared soapy water solution.
Fig. 8A
› After placing, carefully press the film in the middle part with a spatula (B). Now smooth the
film out by stroking it with the spatula diagonally back and forth over the entire horizontal
surface so that no air bubbles remain under the film.
Fig. 8B
› First, smooth the film out by stroking it with the spatula (B) diagonally back and forth over the
entire top surface so that no air bubbles remain under the film. Now press the film carefully
on the inclined surface towards the vehicle.
Fig. 9
› Next, lightly smooth the adhered surface of the foil using a clean microfibre cloth to push out
any residual soapy water solution.
Fig. 10
› Using your fingers and the putty knife or a microfibre cloth, press down on the foil across
the entire curve of the bumper to ensure that no air bubbles or residual soapy water solution
remain under the foil.
Fig. 11
› Remove the upper protective sheet (see arrow). Does not apply for Fabia (PJ3), Karoq (NU),
Enyaq (5AZ) vehicles.
Fig. 12
› Using a clean microfibre cloth, smooth the foil across the entire surface where it is adhered.
Leave for 15 minutes to allow any moisture to evaporate.
12