Skoda 6VE 061 197 Instrucciones De Montaje página 13

› Once this time has elapsed, check the condition of the adhered foil and, if necessary, press
down on the entire surface where it is adhered and smooth it again. Press the foil down par-
ticularly carefully all around the edges and where it curves.
Fig. 13
› After adhering the protective foil to the bumper, park the vehicle in a protected environment
for 12 hours at a temperature between 18 and 30 °C. The period of time for which the vehicle
must be parked is dependent on external temperature conditions.
Please note: Take great care when adhering the foil to the rear bumper.
If the foil is adhered incorrectly and allowed to dry, it cannot be used
again after being removed.
It is therefore important to ensure that the surface is moistened with
soapy water solution before the foil is applied.
It will take at least 48 hours for the adhered foil to look as it is meant to,
once the remaining soapy water solution under the foil has completely
evaporated.
The adhered foil must never cover the parking aid sensors.
Important foil care instructions for the customer
The foil is designed to protect the paint on the loading edge of the rear bumper (from scratch-
es, scuffing, etc.) when loading/unloading luggage.
Slight mechanical wear or a slight change in the colour of the foil does not compromise its
effectiveness in any way and does not constitute a fault (i.e. is not grounds for a complaint).
Do not drive the vehicle through a car wash within 48 hours of adhering the foil.
Wash the foil with a standard solution of mild soapy water. Never clean the adhered foil with a
dirty cloth or sponge, and never use abrasive cleaning agents. When using a pressure washer
(dirt blaster) to wash the vehicle, proceed with extreme care in the area where the foil has been
adhered. The water pressure may damage the foil.
In winter, never use an ice scraper or other tool on the surface to which the foil has been ap-
plied. This would most likely damage (scratch) the foil.
Due to the nature of the foil with component number 657 061 197, 658 061 197, 5E6 061 197A,
5E7 061 197A, 6VE 061 197, 57A 061 197, 5LA 061 197 the component number is not marked on
this component. Please retain these instructions for the entire service life of this product.
EN
13