Publicidad
MAINTENANCE/REPAIR
MAINTENANCE
Activity
Clean sensors
Apply couplant (when
using the Waveguide and
the IS-SU030F2.1 Sensor
Ultrasonic)
Change coupling foil
(when used without
Waveguide)
System Check
Recommendation:
Annual testing of sensors
and measuring electro-
nics (carried out only in
service centers)
SYSTEM CHECK
Plug the sensor cable into the connector labeled "SENSOR".
Connect the end of the sensor cable to the sensor to be tested.
Plug the second sensor cable into the connector labeled "CCT".
Connect the end of the sensor cable to the second sensor.
Clean the measuring surface of the sensors with a soft, lint-free, antistatic cloth.
Stick the coupling foil to the measuring surface of one of the connected sensors.
Press both sensors together on the measuring surfaces and start the System Check
(Senseven App).
Follow the on-screen instructions.
Tools
Soft, lint-free, antitatic cloth
IS-USC1.1 Coupling Agent
Coupling film
„CCT" connection to the mea-
surement electronics, second
sensor cable, second sensor,
Senseven App.
Service centre
Interval
In the case of heavy soiling
before applying the coupling
agent or the coupling foil.
When changing the coupling
foil.
When using the Waveguide:
every 100 measurements or
every 2 - 3 months.
When using the IS-SU030F2.1
Sensor Ultrasonic: at least after
each measurement of a valve. In
the case of heavy soiling, after
each measuring point.
If the coupling foil is heavily
soiled.
When requested by the
Senseven App or if the sensor is
damaged.
Yearly
EN
15
Publicidad
