Publicidad
ENGLISH
READ AND UNDERSTAND THE INSTRUCTIONS
PROTECT YOUR LIFE AND READ THE OPERATING MANUAL
This Operating Manual is part of the device IS-VS1A.1 (model MVS1A01). This Operating
Manual provides important information for safe use of the device.
Before using the device, read these operating instructions carefully and pay particular
attention to the „Safety" information highlighted with the warning symbol.
If you do not follow these instructions or do not understand them, this could lead to death,
severe injuries and damage to the device.
Also read the Safety Instructions before using the device.
You can find these at www.isafe-mobile.com/en/support/downloads
Make sure you have access to this Operating Manual when you need it. You can find the
current Operating Manual at www.isafe-mobile.com/en/support/downloads
Follow all instructions given on the device and on the packaging.
Follow local safety regulations.
Only use the device in explosion hazardous areas of zones 1/21 and 2/22 or outside of
explosion hazardous areas.
Before entering an explosion hazardous area with the device,
•
make sure the smartphone battery is screwed tight.
connect the IS540.1 Smartphone securely to the measurement electronics,
•
•
when using the Waveguide: install the sensor in the Waveguide,
•
make sure the system components are not damaged,
•
make sure that all the labels on the device are readable,
•
ensure that the sensors, Waveguide and Waveguide Lock are grounded by the user or
other i.safe MOBILE GmbH approved accessory when entering the ex zone,
•
make sure that the case is not taken into the ex zone.
If you use the device in an explosion hazardous area,
•
do not disconnect the 16-pin connector between the smartphone and the measurement
electronics,
•
always place the sensors and the Waveguide on a grounded surface,
•
do not damage the device.
Switch off the device immediately and leave the explosion hazardous area without delay if
•
malfunctions occur on the device,
•
you have damaged the housing of the device,
•
you have exposed the device to excessive loads,
•
the labels on the device are no longer readable.
Do not modify the device structurally.
Do not expose the device to high temperatures.
Do not expose the device to strong UV radiation.
Do not expose the device to processes with high electrical charges.
Do not expose the device to aggressive acids or bases.
4
Publicidad
