Johnson JOR50 Manual De Instrucciones página 25

CAUSES OF DAMAGES
Caution!
 Creation of sparks: Metal e.g. a spoon in a glass must be kept at least 2 cm
from the oven walls and the inside of the door. Sparks could irreparably
damage the glass on the inside of the door.
 Water in the hot cooking compartment: Never pour water into the hot cooking
compartment. This will cause steam. The temperature change can cause
damage.
 Moist food: Do not store moist food in the closed cooking compartment for
long periods.
 Do not use the appliance to store food. This can lead to corrosion.
 Cooling with the appliance door open: Only leave the cooking compartment to
cool with the door closed. Do not trap anything in the appliance door. Even if
the door is only slightly ajar, the fronts of adjacent units may be damaged over
time.
 Heavily soiled seal: If the seal is very dirty, the appliance door will no longer
close properly during operation. The fronts of adjacent units could be
damaged. Always keep the seal clean.
 Using the appliance door for standing on or placing objects on: Do not stand
or place anything on the open appliance door. Do not place ovenware or
accessories on the appliance door.
 Transporting the appliance: Do not carry or hold the appliance by the door
handle. The door handle cannot support the weight of the appliance and could
break.
 Liquid that has boiled over must not be allowed to run through the turntable
drive into the interior of the appliance. Monitor the cooking process. Choose a
shorter cooking time initially, and increase the cooking time as required.
 Failure to maintain the oven in a clean condition could lead to deterioration of
the surface that could adversely affect the life of the appliance and possibly
result in a hazardous situation.
INSTALLATION
Fitted units
 This appliance is only intended to be fully fitted in a kitchen.
 This appliance is not designed to be used as a tabletop appliance or inside a
cupboard.
 The fitted cabinet must not have a back wall behind the appliance.
 A gap of at least 45 mm must be maintained between the wall and the base or
back panel of the unit above.
 The fitted cabinet must have a ventilation opening of 250 cm
5
on the front.
2
V.1