Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
LIGHT
SWITCH
Controls
The hood is operated using the slide controls
under the front edge of the hood.
The light switch
turns the halogen lights on
and off.
The blower on / off switch turns the blower on
to the running speed set by the blower speed
control. The blower must be turned on and off
using this switch.
SLOWER
SLOWER
ON ! OFF
SPEED
SWITCH
_,.._//
PILOT
LAMP
The blower speed control
changes the speed of the blower from 1 to 3 position.
The pilot lamp lights up whenever the blower is on.
HEAT SENTR yTM
Your hood is equipped with a HEAT SENTRY
TM
thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature
level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat
can start the blower even if the hood is turned
OFF. When this occurs, it is impossible
to turn the blower OFF with its switch.
if you must stop the blower, do it from the main electrical
panel.
HALOGEN
BULBS
This range hood requires 4 halogen
bulbs
(Type JC, 12V, 20W, G-4 Base).
ALWAYS
SWITCH OFF THE ELECTRiCiTY
SUPPLY
BEFORE
CARRYING
OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Loosen
the
ring
nut
by
turning
it
counterclockwise.
2. Pull the bulb downwards
to remove - DO
NOT ROTATE. CAUTION: BULB MAY BE
HOT!
3. Replace with Type JC, 12V, 20W, G-4 Base
halogen bulb. Do not touch replacement
bulb with bare hands!
-10-
RiNG NUT
Publicidad
