Motor Oil - Garland GAS 650 QG Manual De Instrucciones

Ocultar thumbs Ver también para GAS 650 QG:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English

6.2.3. MOTOR OIL

ATTENTION! The engine of the machine comes
with no oil. Before starting the machine oil must be
added to the oil deposit.
To fill up the oil deposit, insert 0.1l of 20W-40 oil, new
and clean.
Checking the level of oil:
To check the level of oil, do so always with the
machine on a flat surface and in a stable position:
1. Unscrew the oil cap.
2. Clean the oil rod with a rag.
3. Place the rod back in place and screw into
place.
4. Unscrew the oil cap again.
5. Check that the oil level is between the minimum
and maximum levels.
If the oil level is close or below the minimum level,
refill oil until the oil level is close to the maximum
level.
6.2.4. PETROL
Check that there is enough petrol in the petrol deposit
and refill if necessary. To refill with petrol:
1. Choose an adequate area and surface to refill
petrol.
2. Remove the petrol cap.
3. Refill with petrol but never surpassing the level of
the petrol filter that is in the entrance of the petrol
deposit. If petrol covers the petrol filter, petrol could
leak out when the petrol heats up and expands.
4. Screw the petrol cap tightly.
5. Eliminate all the petrol that
could have leaked out
with a dry rag.
WARNING:
- Stop the engine before refilling.
- Do not refill in a closed area or with very little
ventilation.
- Do not smoke when refilling.
- Move the machine at least 3 metres from the
refilling area before starting the machine. Always
use unleaded 95 octane petrol.
6.3. START-UP
6.3.1. CHECKPOINTS BEFORE START-UP
Do not use machine is if it is damaged or
incorrectly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things that may be around.
Check:
- The machine completely and look for loose and
damaged parts (screws, nuts, etc.).
- That there are no fuel leaks.
- That the air filter is clean. Clean the filter if
necessary.
Tighten, repair or replace everything you need before
using the machine.
32/104

Publicidad

Tabla de contenido
loading

Tabla de contenido