Publicidad
Idiomas disponibles
Idiomas disponibles
Controls and Indicators
1
7
8
9
10
13
14
15
Figure 2: Chassis Controls
1. Hour Meter
2. Water Temp.
3. Oil Pressure
4. Breaker
5. Choke, Glow Plug Light
6. Enable
7. Engine Start
8. Key Switch
9. Emergency Stop
10. Riser
11. Boom Extend
12. Jib Raise
13. Boom Raise
14. Turret Rotate
15. Cage Rotate
16. Cage Level
17. Boom Hi/Low Speed
18. Auxiliary Power
19. Riser
Figure 3: Foot Switch
19
20 21 22 23
32
29 30 31
Figure 4: Platform Controls
2
4
3
5
6
11
12
16
17
18
20. Boom Raise
21. Boom Extend
22. Jib Raise
23. Emergency Stop
24. Red-Engine Temp
25. Yellow-Tilt
26. Hi/Low Speed
27. Gas/Prop. Select
Glow Plug Light
28. Aux. Power
29. Turret Rotate
30. Cage Rotate
31. Cage Level
32. Auxiliary Light
33. Horn
34. Generator
35. Boom Speed
36. Joystick/Interlock
37. Key Switch
38. Foot Switch
24 25
27
26
33 34 35 36
Before operating work platform insure that:
Pre-operation and safety inspection has been
completed, and any discrepancies have been
corrected.
The operator has been thoroughly trained on the
operation of the machine.
The work area is clear of all obstructions, holes,
drop-offs, or persons in the route of travel.
The surface is capable of supporting wheel loads.
Refer to figures one and two for control locations.
At any time during operation, press the emergency stop
button to stop all functions in an emergency.
At any time during operation, press the service horn
button to sound an audible warning if necessary.
If National Legislation requires:
Always wear an approved fall restraint properly
attached to designated platform anchorage point
when driving or elevating the machine (see
figure 4).
Attach only one fall restraint to each anchorage
point.
38
28
37
4
Operation
Emergency Stop
Service Horn
Figure 5: Typical Fall Restraint
Anchorage Point
Publicidad
