Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
FUELING
Gasoline
1. Open left turret cover, open fill pipe cap.
(See Figure 8).
2. Fill to capacity with unleaded motor fuel only.
3. Fuel tank full capacity is 159 L [42 US gallons].
Diesel
1. Open left turret cover, open fill pipe cap.
(See Figure 8).
2. Fill to capacity with diesel motor fuel. Use diesel fuel
as per EN950, do not use residual or blend.
3. Fuel tank full capacity is 159 L [42 US gallons].
HYDRAULIC FLUID
1. Check level at sight gauge inside engine compart-
ment right hand side with the platform fully lowered.
(Figure 9)
2. If necessary, fill to capacity with clean (ISO 46
summer - ISO 32 winter) compatible hydraulic fluid.
3. Open filler / breather cap to add hydraulic oil.
4. Replace cap.
5. Properly dispose of waste fluid.
LUBRICATION
Refer to service manual for lubrication chart and
guidelines.
Fuel Fill Pipe
Figure 8: Fuel Fill Pipe
BATTERY MAINTENANCE
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from batter-
ies.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Rinse away any
spilled fluid thoroughly with clean water.
Always replace batteries with UpRight batteries
or manufacturer approved replacements.
Check battery fluid level daily, especially if work platform
is being used in a warm, dry climate.
If electrolyte level is lower than 10 mm (
plates add distilled water only. DO NOT use tap water it
will shorten battery life.
Keep terminals and top of battery clean.
TIRES
Tire selection can affect the stability of the machine. Use
only tires supplied by UpRight unless approved by the
manufacturer in writing. Check air filled tire air pressure
daily 5.5 bar [80 psi].
Hydraulic Oil Filler / Breather Cap
Level Gauge
Figure 9: Hydraulic Oil Filler / Breather Cap
9
3
/
in.) above
8
Publicidad
