Hamilton Beach OG02 Manual De Montaje Y Operacion página 19

ASSEMBLY STEPS
STEP 8: Doors
1. Attach toolbox bracket to back of right door with four (4) M4 x 10 screws as shown in Fig. 8a;
then attach three (3) M4 x 12 screws to back of right door without fully inserting the screws
and hang the toolbox onto the screws as shown in Fig. 8b.
2. Insert the lower left door pin into the hole on the bottom shelf. Push down the upper door pin,
aligning it beneath the hole in door pin bracket, and release pin so that it inserts into the hole
as shown in Fig. 8c.
3. Repeat step 2 for the right door.
4. Insert the nylon knot into the hole on the side panel, then put the match holder in it and
capture it as shown in Fig. 8d.
i
Fig. 8a
Fig. 8b
Fig. 8c
Fig. 8d
19