Descargar Imprimir esta página

Hamilton Beach OG02 Manual De Montaje Y Operacion página 38

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
BEFORE
CALLING
FOR SERVICE:
Please check the following
problems/solutions
before contacting
our service center.
PROBLEM
Burner wilt not light
after turning and
pushing
the knobs
Burner cannot
light
by match
Yellow or orange flame
with gas odor
Low heat with knob
in HI position
Flare=up
Flameout
Flame lifting
Flashback
Grease fire
38
POSSIBLE
CAUSE
SOLUTION
Propane tank is empty.
Refill or replace propane
tank.
Igniter deposited
with
Use clean swab and alcohol to
cooking
residues,
clean.
Igniter damaged.
Replace.
Igniter wires are loose or
Reconnect
or replace with new
fall off.
igniter assembly
with wires.
Improper
alignment
of
Use needlenose
pliers to adjust the
igniter with side burner,
alignment
as shown in Step 11.12
in the manual.
Orifice blocked
Wire is shorting.
No gas
Gas flow is not smooth.
Incorrect
assembly
between
burner and valve
Incomplete
combustion
Gas hose bent or kinked.
Burner or orifice blocked.
Low gas pressure
Grill not preheated.
Excessive
meat fat
Temperature
too high
Grease deposit
High winds
Gas pressure
too high
Burner port blocked.
Grease accumulated
in
food.
Check the orifice for blockage.
Replace with new igniter
assembly
with wires.
Open the LP tank valve or replace
LP tank valve.
Clear burner tubes.
Reassemble.
Call Consumer
Affairs at
1 =800=851 =8900.
Smooth
out the hose.
Clear blockage.
Call the gas dealer.
Preheat the grill for 15 minutes.
Cut off fat before grilling.
Adjust.
Clean.
Find a less windy place.
Call the gas supplier.
Clean burner port.
Turn off knobs and LP tank valve.
Leave lid open and let fire burn out.
Clean the grill after cooling.

Publicidad

loading