Hamilton Beach OG02 Manual De Montaje Y Operacion página 24

ASSEMBLY STEPS
STEP 11" Side Burner
12. The side burner is now fully assembled. This step (step 12) is only necessary if you find later
that you cannot light the side burner by using the side burner knob. Often, this is caused by
poor alignment of the igniter tip with a hole in the side burner. To adjust this alignment, grab
the igniter tip with a pair of needlenose pliers as shown in Fig. 11p, Using gentle force,
move the position of the tip so it is about 1/8" from the bottom of one of the holes in the
burner, as shown in Fig. 11q.
Fig. 11p Fig. 1 lq
24