Silk’n BRIGHT LUX FAC03 Manual De Usuario página 14

Mode
Red LED light
+ Infrared +
cooling
7.2 Switching on/off and selecting an LED mode
1. Press the LED button ( )
The LED light + Infrared surface
LED mode.
2. Press the LED button ( ) a second time.
The device is switched to the blue LED mode.
3. Press the LED button ( ) a third time.
The device is switched to the yellow LED mode.
4. Press the LED button ( ) a fourth time.
The device is switched to the purple LED mode.
5. Press the LED button ( ) a fifth time.
The device is switched to the red LED + cooling mode.
In this mode, the LED light + Infrared surface illuminates red
and the cooling surface
cooling mode indicator light
6. Press the LED button ( ) a sixth time.
The device is switched off.
Tip: You can directly select the red LED + cooling mode without
pressing the LED button several times. To do so, press and hold
the LED button ( ) in any LED mode until the red LED + cooling
mode is activated.
7.3 How to use
1. Thoroughly clean and dry your face. Make sure it is free from
any make-up or dirt.
2. Turn on the LED light + Infrared surface
mode (see instructions in the previous chapter).
3. Move the LED light + Infrared surface over your face in
circular movements.
• Once the LED light + Infrared surface starts, you hear a beep
sound every 30 seconds, hinting to you about the time that has
passed. The device automatically switches off after 10 minutes
(in any LED mode) or 2 minutes (red LED + cooling mode).
Note that whenever you change the mode during the LED
session, the timer will be reset to zero.
Best for
Reduces puffy eyes for a brighter
appearance
once.
8
5
cools down to around 6 °C. The
6
also turns on.
7
is switched on in the red
and select an LED
5
EN
14