Publicidad
Idiomas disponibles
Idiomas disponibles
English
WARNING
● Keep your finger off the trigger except during
stapling operation, because serious injury could
result if the push lever accidentally contacts you
or others in work area.
● Keep hands and body away from the discharge
area. This metabo HPT stapler may bounce from
the recoil of driving a staple and unwanted
subsequent staple may be driven, possibly
causing injury.
NOTE
○ If all warnings and instructions are followed, safe
operation is possible with system: SINGLE
SEQUENTIAL ACTUATION MECHANISM.
○ Always handle staples and package carefully. If
staples are dropped, collating bond may be broken,
which will cause mis-feeding and jamming.
○ After stapling:
1. remove battery from the Stapler;
2. remove all staples from the Stapler;
ADJUSTING THE STAPLING DEPTH
To assure that each staple penetrates to the same depth,
be sure that the Stapler is always held firmly against the
workpiece.
If staples are driven too deep or shallow into the
workpiece, adjust the stapling in the following order.
(1) Remove the battery from the Stapler.
(2) If staples are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in quarter-turn increments.
If staples are driven too shallow, turn the adjuster to
the deep side.
20
Battery
(2)
Too Deep
(2)
Too Shallow
(3) Stop turning the adjuster when a suitable position is
reached for a stapling test.
(4) Connect the battery to the Stapler.
ALWAYS WEAR SAFETY GLASSES.
Perform a stapling test.
(5) Remove the battery from the Stapler.
(6) Choose a suitable position for adjuster.
USING THE HOOK
WARNING
When using the hook, remove the battery. Pay
sufficient attention so that the main equipment
does not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
1. Removing the hook.
Remove the screws fixing the hook with Philips screw
driver.
Turn Adjuster
Flush
Turn Adjuster
Flush
Groove
Hook
Screw
Publicidad
