Descargar Imprimir esta página

Metabo HPT N 1804DB Instrucciones Y Manual De Seguridad página 21

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool
and tighten the screws to fix the hook firmly.
Groove
NOTE
Hook can be used as a hanger.
USING THE NOSE CAP
WARNING
When attaching or detaching the nose cap, be
sure to remove your finger from the trigger and
remove all remaining fasteners and the battery
from the stapler.
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
(1) Remove all remaining fasteners and battery from
stapler.
(2) Put the nose cap to the toe of the push lever.
(3) When not using the nose cap, secure in the storage
compartment located on the reverse side of the
magazine.
Hook
Screw
Push Lever
Nose Cap
Magazine
NOTE
The nose cap may reduce stapling depth due to its
thickness. Re-adjustment of stapling depth is
required.
CLEARING A JAM
If staples are jammed in firing head, remove it, and adjust
the stapling in the following order.
CAUTION
Remove the battery from the Stapler.
(1) Remove the battery from the Stapler.
(2) Remove all staples.
(3) Release the Lock lever and open guide plate.
Lock lever
(3)
Guide Plate
(4) Remove the jammed staple with a slotted-head
screwdriver.
CAUTION
● NEVER hit the driver blade.
● NEVER point the tool at yourself or another
person, to avoid risk of injury by mis-firing.
Even if the battery is removed from the stapler,
there is still energy of compressed remaining
inside.
English
Nose Cap
21

Publicidad

loading