Publicidad
Idiomas disponibles
Idiomas disponibles
English
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when the
battery is disassembled and modified (such as
disassembly and replacement of cells or other internal
parts).
SERVICE AND REPAIRS
WARNING
● Only service personnel trained by metabo HPT, distributor or employer shall repair the Stapler.
● Use only parts supplied or recommended by metabo HPT for repair.
All quality Staplers will eventually require servicing or replacement of parts because of wear from normal use.
NOTE
Specifications are subject to change without any obligation on the part of metabo HPT.
Maintenance chart
ACTION
Clean magazine and feeder
mechanism.
Keep push lever working properly.
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a metabo HPT authorized service center for assistance.
PROBLEM
Stapler doesn't operate.
24
WHY
Prevent a jam.
Promote operator safety and efficient
Stapler operation.
CHECK METHOD
Stapler not enough pressed against
workpiece.
Trigger not enough pulled.
More than 4 seconds pass from push
lever ON to trigger ON. (Time out
function)
Lock lever (Trigger lock function) is
"ON" position.
Machine is too cold (below 23°F
(-5°C)) or too hot. (LED light blinks at
regular intervals) (See page 15)
Damaged internal electronics.
HOW
Blow clean daily.
Blow clean daily.
CORRECTION
Hold stapler firmly and press to the
workpiece completely.
Pull the trigger firmly.
Make sure that less than 4 seconds
pass between push lever ON and
trigger ON.
Set Lock lever to "OFF" position.
(See page 16)
Allow the stapler to cool or warm-up
throughly in adequate condition.
Contact metabo HPT for inspection.
Publicidad
