Stanley FATMAX FMXCMS2020TE Manual De Instrucciones página 20

If in doubt consult a qualified electrician.
There are no user serviceable parts inside this product
G
except those referred to in the manual. Always refer
servicing to qualified service personnel. Never remove
B
any part of the casing unless qualified to do so; this unit
contains dangerous voltages.
Warning!
For your protection if this product is to be used outdoors it
should not be exposed to rain or used in damp locations. Do
not place the product on damp surfaces, use a workbench
if available. For added protection use a suitable residual
current device (R.C.D.) at the socket outlet.
Note: If the mains cable requires replacing it must be
replaced with an identical one and fitted by a qualified
person.
6.3 I/O switch (On/Off) (Fig. 7-8)
To switch on the compressor, pull out the knob (ref. 8) to
position I (ON).
To switch off the compressor, press the knob (ref. 8) in
again to position O (OFF).
6.4 Adjusting the pressure
● You can adjust the pressure on the pressure gauge (ref.
6) using the pressure regulator (ref. 7).
● The set pressure can be taken from the quicklock
coupling (ref. 5).
6.5 Setting the pressure switch
The pressure switch is set at the factory.
● When the upper calibration value (set by the manufacturer)
has been reached, the compressor stops.
When air is used, the compressor restarts automatically
when the lower calibration value is reached.
● The compressor continues to operate according to this
automatic cycle until the I/O switch is turned.
7. TRANSPORT
– Pull telescopic handle out until it locks into place. (Fig. 4).
Caution!
The telescopic handle is only for pulling the unit. (Fig.
5).
DO NOT lift the unit by this handle.
– To collapse the handle, apply pressure for the first few
inches to unlock, then slide the handle strait in until it
stops. (Fig. 4).
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element
Draining tank condensate
Two person lift.
Do not attempt to lift the compressor by yourself.
Lifting the compressor is a two-man operation
requiring the assistance of another person. The
compressor is lifted by gripping hand holds 14 and
15. (Fig. 6)
8. CLEANING AND MAINTENANCE
Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Wait until the compressor has completely cooled
down. Risk of burns!
Always depressurize the tank before carrying out any
cleaning and maintenance work.
8.1 Cleaning
● Keep the safety devices free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
● We recommend that you clean the appliance immediately
after you use it.
● Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure
that no water can get into the interior of the appliance.
● You must disconnect the hose and any pneumatic tools
from the compressor before cleaning. Do not clean the
compressor with water, solvents or the like.
8.2 Condensation water (Fig. 3)
The condensation water must be drained off each day
by opening the drain valve (ref. 3) (on the bottom of the
pressure vessel).
1. Verify that the compressor is turned Off.
2. Holding the handle, tilt the compressor toward the
3. Open gently the drain valve.
4. Keep the compressor tilted until all moisture has been
5. Close the drain valve.
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
Daily and at the end of work
20
Warning!
Warning!
Warning!
Warning!
drain valve so that it's set in a lower position.
removed.
EVERY 100 HOURS
●