Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR THE USER
EXTRAORDINARY MAINTENANCE
The oven requires small maintenance interventions should, in time, those parts subject to wear, such as gaskets, lamp, etc, require replacing.
Instructions for these types of interventions are supplied below.
Disconnect the oven from the mains before every intervention which requests access to the live parts.
Replacement of the internal lighting lamp
Remove protection cover "A" by unscrewing it anti-clockwise, replace lamp "B" with another of the same type.
Mount the protection once again and screw it clockwise until it is tight (fig. 21).
Only use oven lamps (T300°C) 15W or 25W depending on models.
Never touch the lamp with bare fingers, always use protective gloves.
Only use lamps obtained from authorised after-sales centres.
Dismantling of the door
Lift levers "2" up to the ledge with hinges "1" and hold the door at the two sides with both hands near the same hinges.
Lift the door upwards forming an angle of approx. 45° and carefully extract it.
For the mounting, place hinge "2" in the appropriate grooves, therefore leave the door to lean downwards, ensure it remains blocked in
grooves "3", then release levers "1" (fig. 22).
Dismantling of oven door gaskets
To better clean the oven, the door gasket can be removed.
With the door dismantled, lift the tongues located at the angles, as shown in
the figure.
Once cleaning is completed, re-mount the gaskets keeping the longest side
horizontal and place the tongues in the respective holes, starting from the
upper ones.
Disassembling the shelf supports
1. First slide the extraction guide out of the side wall by pulling it forwards.
2. Slide the rear extraction guide out of the side wall and remove it.
1
2
1
2
To reinstall the supports, follow the procedure indicated in reverse.
EN
33
Publicidad
