Toshiba TCB-SC642TLE Manual De Instalación página 10

Gap
Gap
Coin
10
4. Address switch setting
To avoid an electric shock hazard,
DO NOT touch any terminal on the
WA R N I N G
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
hand when power is supplied.
Dip switch
How to reach the P.C. board
Remove the flat-top screw on the bottom of the back case. When you
open up the decorative cover, you will see two notches under the
control unit. Inset a coin or other flat object into these notches and
pry off the back case. The P.C. board on the back of the control unit is
now visible.
Fig. 9
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
All bits are set off
when shipped from
factory.
PCB of the control unit
Fig. 8
OI-607-10EG