Kenmore 216.37040 Manual Del Propietário página 13

WARNING
Electrical Shock and Personal
injury Hazard
Disconnect electrical supply
before servicing or cleaning
the unit, Failure to do so could
result in electrical shock or
personal injury from vacuum
cleaner suddenly starting.
TO REMOVE BELT
Lay cleaner flat and flip cleaner to expose
nozzle base. To remove nozzle guard, slide
lock A to unlock position, to the left. Then
depress lock B to unlock nozzle guard.
_A
Rotate/pivot the
nozzle guard and
pull off
Lift and remove
brushroll. Dispose
of old belt.
13
TO REPLACE BELT
OR BRUSHROLL
_,_ Place new belt in area
of brushroll without
bristles.
_ lace brushroll
shutoff pedal in
"Carpet" position.
Slide belt onto motor
shaft. Ensure to loop
the belt around the
belt lifter shaft.
With new belt in place,
pull and slide brushroll
into nozzle making
sure that the brushroll
end caps are in the
correct orientation (see
diagram for end cap
orientation). Rotate
brushroll manually
to make sure belt is
properly aligned.
Secure by aligning
the three (3) tabs
in the base slots.
To reattach nozzle
guard, rotate/pivot
back into position.
To secure nozzle
guard, push lock B
down to lock position.
Slide lock A into lock
position, to the right.