Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Electrical
Shock and Personal
injury Hazard
Disconnect
electrical
supply
before
servicing
or cleaning
the
unit.
Failure
to do so could result
in electrical
shock
or personal
injury from vacuum
cleaner
sud-
denly starting.
TO REMOVE
LIGHT BULB
1. Disconnect power cord from elec_ical outlet.
2. Press handle release
pedal and lay
vacuum
cleaner
back.
3. Grasp
the edge
of the exhaust
cover.
Pull out edges
of exhaust
cover
and lift off.
4, Remove
the two (2) screws
from the
lens cover.
Do not use a bulb rated over 9W
(13V). During extended
use, heat
from the bulb could overheat
surrounding
plastic parts.
5. Insert flat blade of
screwdriver
into slot at
top of the lens.Lift
the
lens cover to remove.
_%_ ._:_--
6. Pull bulb out of socket.
Do NOT twist. Gently
push replacement
bulb
into socket to replace.
7. Snap lens cover back
into place and secure
the headlight
lens by
replacing
the two screws.
Replace exhaust
cover.
Note: See separate
PARTS
LiST for bulb
number.
1. Locate the lower intake hose.
2. Rotate lower intake hose cuff clockwise
into the unlock position.
3, Disconnect
the hose by
pulling down on the lower
intake hose cuff.
4. Remove debris from
inside the hose.
1. Follow instructions on page 13 for
removing
nozzle guard and brushroll.
2. Once brushroll
is
removed,
locate the
nozzle valve (A).
_ ._jl!'__
A
3, Remove
debris
from inside the nozzle
valve.
4, Return
brushroll
and nozzle
guard.
14
Publicidad
