Publicidad
6. Remove the mask parts from the water/detergent mixture and rinse with 1.5 gallons (5 liters)
of water for at least 1 minute.
7. Air dry mask parts out of direct sunlight. Make sure the entire mask is dry before use.
Cleaning Instructions for Fabric Parts
Caution: Do not place the fabric parts into the dryer.
Hand wash fabric parts weekly, or as needed.
1. Disassemble the mask (see Disassembly section).
2. Inspect the fabric parts for damage or wear. Discard and replace any components as
necessary.
3. Mix 1 teaspoon (5 ml) of liquid detergent per 1 gallon (3.8 liters) of warm potable water
(80-90°F/27-32°C).
4. Completely submerge the fabric parts in the warm water/detergent mixture and soak for
5 minutes.
5. Agitate the fabric parts in the water/detergent mixture for an additional 5 minutes.
6. Remove the fabric parts from the water/detergent mixture and rinse with 1 gallon (3.8 liters)
of warm water for at least 1 minute.
7. Lay the fabric parts flat or line dry. Make sure the entire mask is dry before use.
6 Assembly and Disassembly
Cautions:
• The tubing is permanently attached to the mask frame. Do not attempt to remove the
tubing from the frame.
• Do not pull on the mask tube to separate it from CPAP tubing.
Assembly
1. The inside of the wings and the headgear are marked with "R" and "L" to show the right and
left sides. Match the left ("L") side of the headgear to the left wing. Make sure each "L" is
facing up. f
2. Insert the tip of the left wing into the slot in the left side of the headgear fabric. Feed the
wing through the length of the fabric. g
3. Hook the fabric around the edges of the wing, making sure the wing is fully covered. h If
any part of the wing is visible
4. Repeat with the right ("R") side of the wing and headgear.
5. Align the cushion with the frame. The inside of the cushion is marked with an "R" and an "L"
to show the left and right sides. Make sure the "R" and "L" are facing up. The magnets in the
cushion will snap into place. i
6. Confirm that the cushion is firmly attached to the frame. j
Note: If placed in the frame upside down, the cushion will not connect to the magnets.
, adjust the fabric.
5
Publicidad
