Makita LS1017 Manual De Instrucciones página 11

1
► 1 . Switch for laser
CAUTION:
• LASER RADIATION
Do not stare into beam.
• Before shifting the laser line or performing main-
tenance adjustment, be sure to unplug the tool.
To turn on the laser beam, press the upper position (I)
of the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1
► 1 . Screw holding the laser unit box
Laser line is factory adjusted so that it is positioned
within 1 mm (0.04") from the side surface of the blade
(cutting position).
NOTE:
• When laser line appears dim and hard to see
because of direct sunlight, relocate the work
area to a place where there is less direct
sunlight.
Replacing the dry cells for laser unit
► 1 . Dry cell
Remove the lid for the dry cells for laser unit by sliding
while pressing it. Take out the old dry cells and put the
new ones as shown in the figure. After replacing, return
the lid to cover it.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no
longer easily visible, unplug the saw and remove and
clean the lens for the laser light carefully with a damp,
soft cloth. Do not use solvents or any petroleum-based
cleaners on the lens.
NOTE:
• When laser line is dim and almost or entirely
invisible because of the direct sunlight in the
indoor or outdoor window-by work, relocate the
work area to a place not exposed to the direct
sunlight.
ASSEMBLY
WARNING:
• Always be sure that the tool is switched off
and unplugged before working on the tool.
Failure to switch off and unplug the tool may
result in serious personal injury.
11 ENGLISH
1