Kärcher T 250 T-Racer Manual Del Usuario página 5

Preparing the Appliance
Selection of the nozzles
You need to use the matching nozzles to
ensure that your pressure washer works
properly.
For pressure washers with a
pressure from 1700 psi to 2000 psi
Use black nozzles.

Note:The black nozzles are pre-
mounted.
For pressure washers with a
pressure from 1400 psi to 1650 psi
Use grey nozzles.

Note:To ensure a trouble free opera-
tion of your pressure washer, you
must replace the two black nozzles
with the grey nozzles.
Replacement of nozzles
Illustration

A Remove the clip.
B Pull out the yellow nozzle.
C Insert the grey nozzle.
D Re-insert the clip.
Application
Note: Always use Kärcher water filter
(order no. 4.730-059.0) during suction
operations of the pressure washer.
Cleaning horizontal surfaces
Note:Outdoor surfaces should be swept
before the T-Racer is used to avoid
damaging the nozzles.
Connect the T-Racer and both wands
with the trigger gun.
Illustration
Connect lower wand with T-Racer.

1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Connect upper wand with lower

wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Connect trigger gun with upper

wand.
1 Press the bayonett connection into
the bayonet catch, then turn by 90°
until it locks into place.
2 Tighten the union nut.
Illustration
Caution
Do not run over freestanding corners.
English 5