Publicidad
1 Robotclean Accu XS Operating Manual and Parts List
General information
Dear customer,
This operating manual contains important information on commissioning and use. Read the operating manual carefully before using the pool cleaner. This applies particularly to the
safety advice. Otherwise, you may injure yourself or damage the pool cleaner. Keep the operating manual for future use. If you pass the pool cleaner on to a third party, be sure to hand
over this operating manual as well. These operating instructions can also be downloaded as a PDF file from our website www.outsideliving.com.
Safety instructions
This device may be used by children from the age of 8 upwards and also by people with physical, sensory or mental disabilities or lacking suitable knowledge and experience, provided
they are supervised or have been instructed in the use of the device and understand the resulting hazards. Cleaning and user maintenance must not be carried out by unsupervised
children.
The pool cleaner is intended exclusively for private use only and is not suitable for commercial applications. Only use the pool cleaner as described in this operating manual. Any
other use is considered improper and can lead to damage to property and/or personal injury. The pool cleaner is not a toy. The manufacturer or dealer accepts no liability for damage
resulting from improper or incorrect use.
• Make sure that the pool cleaner is placed on a level and stable surface for assembly.
• Only use the power supply unit in a properly installed socket with a mains voltage of 230 V AC indoors.
• The power supply for the power supply unit must be at least 3.5 metres away from the pool. The power supply must be supplied via a residual current circuit breaker (RCCB)
with a rated residual current of no more than 30 mA.
• The power supply unit may not come into contact with water or moisture.
• Remove the power supply unit from the socket immediately if a fault occurs or if the appliance is not used for a longer period of time.
• Only use the supplied power supply unit.
• Do not pull the power supply unit by the cable to remove the plug from the socket.
• Lay the power supply unit cable so that it cannot come into contact with sharp-edged or hot objects.
• Keep the pool cleaner and the power supply unit out of the reach of children.
• Do not place the pool cleaner or the power supply unit near extreme temperatures and protect the transformer from moisture
• The power cable of the power supply unit cannot be replaced. If the cable is damaged, the affected device may no longer be used and must be disposed of properly.
• Do not enter the swimming pool when the pool cleaner is in operation.
• Before using your pool cleaner, remove all objects from the pool that could affect the performance of the pool cleaner.
• Do not switch the pool cleaner on before it is in the water.
• Take the pool cleaner out of the pool after each use. If you leave the pool cleaner in the pool all the time, this may result in additional service requirements.
Check the pool cleaner and scope of delivery
Risk of damage,
If you open the packaging carelessly with a sharp knife or other pointed object, the pool cleaner or accessories may be damaged. Remove the pool cleaner from the packaging. Check
whether the pool cleaner or the accessories are damaged. If this is the case, contact the dealer immediately.
Assembly
Once you have removed the pool cleaner from the packaging, you can put the pool cleaner into operation. Proceed as follows:
• Install the spatula (F) to boost the suction effect if the pool floor is very dirty. It is not recommended to install the spatula (F) if the pool floor is uneven or has many holes.
This can cause the pool cleaner to get caught and damage the foil
• Mount the handle (A) on the pool cleaner with both included screws
• Connect the power supply unit (G) to a suitable socket (see safety instructions), insert the charging plug into the charging socket (H) underneath the pool cleaner and
fully charge the pool cleaner (4 hours)
• To protect the swivel plates, please note that the pool cleaner must not be placed upside down
• The indicator lamp on the charger must be illuminated red during the charging process
• The indicator lamp on the charger lights up green after the pool cleaner has been fully charged
• After you have removed the charging plug from the charging socket (H), make sure that the rubber plug is fitted to the charging socket (H)
• Charge up the cleaner fully before each use
• Mount the retrieval hook (E) on a suitable rod (not included in the scope of delivery)
Commissioning
• Only use the pool cleaner at temperatures between 10 °C and 35 °C
• Hold the pool cleaner by the handle (A), immerse it in the water and make rotating movements so that air can escape from the pool cleaner. S
• Switch the pool cleaner on at the on/off switch (I) underneath the pool cleaner, carefully lower it into the water and carefully lower it to the bottom using the retrieval hook (E)
• The pool cleaner emits an acoustic signal as long as the pool cleaner is not completely submerged in water
• The pool robot starts automatically after approx. 5 seconds.
• Make sure that the pool cleaner is not lowered along the wall, as this can damage the foil/pool
Setting the running property
The pool cleaner has 2 adjustable wheels (19). Turning the wheels changes the running behaviour of the pool cleaner. To adjust, open the two buckles (22) and remove the chassis (D).
Remove the two wheels and fit them according to the following guidelines for the following pools:
Manual RobotClean Accu XS 2023_1.indd 2
Manual RobotClean Accu XS 2023_1.indd 2
06.12.23 11:36
06.12.23 11:36
Publicidad
