Publicidad
Make sure that the pool cleaner is not lowered along the wall, as this can damage the foil/pool
•
Setting the running property
The pool cleaner has 2 adjustable wheels (19). Turning the wheels changes the running behaviour of
the pool cleaner. To adjust, open the two buckles (22) and remove the chassis (D). Remove the two
wheels and fit them according to the following guidelines for the following pools:
1 Robotclean Accu XS Operating Manual and Parts List
Combination
Combination
A – C
A – C
B – C
B – C
C – C
C – C
A – B
A – B
Cleaning process
General advice
-
The Accu XS RobotClean is intended for regular cleaning of the pool floor.
-
The robot must be used in clean water.
-
The pH-value of the pool water should be between 7.0 and 7.4.
-
When commissioning the pool after winter storage, the floor must be cleaned for the first time
Cleaning process
with a landing net or vacuum cleaner before the robot is used.
The pool cleaner works according to the chaotic cleaning principle, which means that it automatically
General advice
changes direction as soon as it touches the pool wall. The battery is drained after approx. 50 minutes
- The Accu XS RobotClean is intended for regular cleaning of the pool floor.
of cleaning. Then remove the pool cleaner, charge it according to the installation instructions and carry
- The robot must be used in clean water.
out the cleaning process again if necessary.
- The pH-value of the pool water should be between 7.0 and 7.4.
The pool cleaner and filter should be cleaned after every cleaning process.
- When commissioning the pool after winter storage, the floor must be cleaned for the first time with a landing net or vacuum cleaner before the robot is used.
The pool cleaner works according to the chaotic cleaning principle, which means that it automatically changes direction as soon as it touches the pool wall. The battery is drained after
approx. 50 minutes of cleaning. Then remove the pool cleaner, charge it according to the installation instructions and carry out the cleaning process again if necessary.
The pool cleaner and filter should be cleaned after every cleaning process.
Periods out of use
Periods out of use
The pool cleaner must be dried sufficiently after finishing cleaning. Whenever the pool cleaner is not in
use, it should be stored in a shady and well ventilated place. Frost and direct sunlight should be
avoided.
The pool cleaner must be dried sufficiently after finishing cleaning. Whenever the pool cleaner is not in use, it should be stored in a shady and well ventilated place. Frost and direct
sunlight should be avoided.
Maintenance and care
Maintenance and care
Cleaning the filter
Open the two buckles (22), take off the cover (B) and remove the filter (12). Clean the filter (12) and
Cleaning the filter
the inside of the chassis (D) under a tap or hose
Open the two buckles (22), take off the cover (B) and remove the filter (12). Clean the filter (12) and the inside of the chassis (D) under a tap or hose
Cleaning the housing
Only use water and a soft cloth. Be careful not to apply too much pressure to the housing, otherwise it
Manual RobotClean Accu XS 2023_1.indd 3
Manual RobotClean Accu XS 2023_1.indd 3
may be destroyed. Do not use a coarse sponge or detergent.
Suitable for pool
Suitable for pool
Suitable for most pools
Suitable for most pools
For smaller angles than A – C
For smaller angles than A – C
For rectangular or long pools
For rectangular or long pools
For round pools
For round pools
Cleaning the housing
Only use water and a soft cloth. Be careful not to apply too much pressure to the
housing, otherwise it may be destroyed. Do not use a coarse sponge or detergent.
06.12.23 11:36
06.12.23 11:36
Publicidad
