Orbegozo SV 2670 Manual De Instrucciones página 14

SV 2670
FILLING WATER
1. Before filling water, please pull out the plug first.
2. Set the steam control to the minimum position.
3. Pull down the cover of water filling mouth, and then fill water.
SPRAYING
Press the spraying button, steam will be sprayed out from the spraying
nozzle. At that time, you should keep enough water in the water tank.
STEAM IRONING
1. Use steam ironing, turn the steam control to minimum position and set the
temperature control at the ".", ".." or "..." position.
2. After the indicator goes out, turn the steam control to the suitable
position, steam will be sprayed, ironing can start.
BURSTING STEAM
This function proportions extra steam for eliminating wrinkles.
- Press the steam blast button (C). Wait a few seconds until vapour
penetrates
the fibres of the garment before pushing the button again. For optimum
steam
quality, do not apply more than three successive blasts.
- The spray button has to be pressed repeatedly to release the first spray
DRY IRONING
Turn the steam control to minimum position, set the temperature control to
the suitable position, you can dry ironing.
SELF CLEANING
It is important to self-clean the appliance at least once a month to remove
calcium and any other built-up minerals inside the iron.
- Fill the water tank up to half with water
- Place the iron in a vertical position, plug in to the mains and select
the
maximum temperature.
14