Publicidad
Idiomas disponibles
Idiomas disponibles
Compound cutting
Compound cutting is the process in which a bevel
angle is made at the same time in which a miter angle
is being cut on a workpiece. Compound cutting can be
performed at the angle shown in the table.
Miter angle
Left and Right 0° - 45°
When performing compound cutting, refer to the section
for press cutting, slide (push) cutting, miter cutting and
bevel cut.
Cutting crown and cove moldings
Crown and cove moldings can be cut on a compound
miter saw with the moldings laid flat on the turn base.
There are two common types of crown moldings and
one type of cove moldings; 52/38° wall angle crown
molding, 45° wall angle crown molding and 45° wall
angle cove molding.
► Fig.44: 1. 52/38° type crown molding 2. 45° type
crown molding 3. 45° type cove molding
There are crown and cove molding joints which are
made to fit "Inside" 90° corners ((a) and (b) in the figure)
and "Outside" 90° corners ((c) and (d) in the figure.)
(a) (b)
1. Inside corner 2. Outside corner
1
(b)
(a)
(b)
(a)
1. Inside corner 2. Outside corner
Bevel angle
Left 0° - 45°
(c) (d)
1
2
(a)
(b)
(a)
(b)
(d)
(c)
(a)
(b)
Measuring
Measure the wall width, and adjust the width of the
workpiece according to it. Always make sure that width
of the workpiece's wall contact edge is the same as wall
length.
► Fig.45: 1. Workpiece 2. Wall width 3. Width of the
workpiece 4. Wall contact edge
Always use several pieces for test cuts to check the
saw angles.
When cutting crown and cove moldings, set the bevel
angle and miter angle as indicated in the table (A) and
position the moldings on the top surface of the saw
base as indicated in the table (B).
In the case of left bevel cut
1. Inside corner 2. Outside corner
Table (A)
–
Molding
position
in the
figure
For
inside
corner
For
outside
corner
Table (B)
–
2
For inside
corner
For outside
corner
24 ENGLISH
(a) (b)
(c) (d)
1
2
Bevel angle
52/38°
45° type
type
(a)
Left
Left 30°
33.9°
(b)
(c)
(d)
Molding
Molding
position in
edge against
the figure
guide fence
(a)
Ceiling
contact edge
should be
against guide
fence.
(b)
Wall contact
edge should
(c)
be against
guide fence.
(d)
Ceiling
contact edge
should be
against guide
fence.
Miter angle
52/38°
45° type
type
Right
Right
31.6°
35.3°
Left
Left
31.6°
35.3°
Right
Right
31.6°
35.3°
Finished
piece
Finished
piece will be
on the Left
side of the
circular saw
blade.
Finished
piece will be
on the Right
side of the
circular saw
blade.
Publicidad
