Num'axes PIE1061 Manual De Instrucciones página 25

NOTE: Don't mix battery types (alkaline, lithium and Ni-MH)! This may cause
permanent damage not covered by the guarantee.
Remove the batteries from the camera if you are not using it for 3 months or more.
The batteries could leak and damage your product.
3.2. Solar panel
The device can also operate with a solar with built-in battery (12V/2A).
You can purchase a 12V solar panel at any time on www.numaxes.com.
3.3. External power supply
The device can also operate with an external power supply (12V/2A).
We recommend removing the AA batteries when an external power supply is used.
You can purchase a 12V power supply at any time on www.numaxes.com.
4. Installing the memory card
The camera doesn't have an internal memory.
Using a memory card is required to operate the camera
(micro-SD card from 4GB up to 32GB maximum – class 10
minimum).
You can purchase micro-SD cards at any time at
www.numaxes.com.
In SETUP mode, if no memory card is inserted, the LDC
screen displays "No memory card".
Before inserting or removing the memory card, the
camera must be turned off (switch in the OFF position).
Failing to do so may cause loss of or damage the files
already recorded on the card.
Formatting the memory card in the trail camera before using it for the first time is
strongly recommended, especially when the card has been used in other devices. A
memory card formatted in another device may not be compatible.
When the memory card is full, the LCD screen indicates "Memory full".
Guide PIE1061 – Juillet 2023 – ind. A - 25/112