Kenmore Aqualite HF5010 Manual De Uso Y Cuidado página 21

CLEANING THE BRUSH ROLLER COVER
2. Rinse the brush roller cover
with clean water.
CLEANING & REPLACING THE BRUSH ROLLER
1. Remove the brush roller
cover from the floor head. See
instructions in CLEANING THE
BRUSH ROLLER COVER (page
20-21).
2. Remove the brush roller by
grabbing the brush roller tab
and pulling upward.
Brush Roller Tab
3. Take out the brush roller
cleaning tool from the handle
of the cleaning tool. Using
the brush roller cleaning tool,
remove the hair and debris
wrapped around the roller.
After use, put the brush roller
cleaning tool back to the
handle.
3. Replace the brush roller cover
to the floor head until you
hear a "click". When replacing,
always latch the brush cover
into place to avoid leakage.
Click!
4.Wash the brush roller with
clean water.
5. Put the brush roller into the
accessory holder, and allow
it to dry completely before
reinstalling.
- 21 -