Installation Procedure - Franke FH 604-1E 4I T PWL Instrucciones Para El Uso E Instalacion

Built-in induction hob
opening dimensions
OVENS EQUIPPED WITH
A COOLING FAN
Installing the foam gasket

Installation procedure

All manuals and user guides at all-guides.com
A 580mm
B 510mm
C 560mm
D 490mm
E 53mm
F
10mm
G 50mm
H
5mm
• Induction hob may be built into the 25 to 40 mm thick worktops.
• Bottom kitchen element must not have a drawer. It must be fitted with a horizontal plate
20 mm away from the worktop bottom surface. Space between the plate and the hob
must be empty and no objects may be stored or kept there.
• Rear side of the kitchen element must also have a 50 mm high opening along the entire
width of the element, and the front part must have an opening of no less than 5 mm.
• Incorporation of the oven under the induction hob is permissible for ovens equipped
with a cooling fan.
Prior inserting the oven, it is necessary to remove the rear kitchen element panel in the
area of the oven opening.
Equally, the front part of the element must have an opening of no less than 5 mm.
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass ceramic (glass) cooking hob. Do
not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
• Remove the protective film from the gasket.
• Then, attach the gasket to the lower side of the glass, approximately 2-3 millimetres
from the edge. The gasket must be attached along the entire length of the glass edge
and should not overlap at the corners.
• When installing the gasket, make sure that the glass does not come into contact with
any sharp objects.
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply (see instructions for the connection
of the cooking hob to mains power supply).
• Put the supplied springs in their places.
• Insert the hob into the cut aperture.
• Press the hob firmly towards the worktop from above.
18