AEG HK857870XB Manual De Instrucciones página 48

5.6 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a single
cooking session.
Set the heat setting for the selected cooking
zone and then set the function.
1. Press . 00 appears on the timer
display.
2. Press or to set the time (00-99
minutes).
3. Press to start the timer or wait 3
seconds. The timer begins to count down.
To change the time: select the cooking zone
with and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a signal
sounds and 00 blinks. The cooking zone
deactivates. Press any symbol to stop the
signal and blinking.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate. The heat setting shows 00.
1. Press .
2. Press or to set the time.
The timer finishes counting down, a signal
sounds and 00 blinks. Press any symbol to
stop the signal and blinking.
To deactivate the function: press
. The remaining time counts back to 00.
5.7 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones.
The hob controls heat settings to protect the
fuses of the house installation.
48 ENGLISH
or .
and press . The
and
• If the hob reaches the limit of maximum
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected last is always prioritised. The
remaining power will be divided between
the previously activated cooking zones in
reverse order of selection.
• For cooking zones that have a reduced
power, the control bar blinks and shows
the maximum possible heat settings.
• The cooking zones will continue operating
with the reduced heat setting. Change the
heat settings of the cooking zones
manually, if necessary.
5.8 Menu structure
The table shows the basic menu structure.
User settings
Sym‐ Setting
bol
b Sound
H Hood mode
E Alarm / error histo‐
ry
To enter user settings: press and hold
for 3 seconds. Then, press and hold
settings appear on the timer of the left
cooking zones.
Navigating the menu: the menu consists of
the setting symbol and a value. The symbol
appears on the rear timer and the value
appears on the front timer. To navigate
between the settings press
timer. To change the setting value press
or on the front timer.
To exit the menu: press
OffSound Control
You can activate / deactivate the sounds in
the Menu > User settings.
Refer to "Menu structure".
Possible options
On / Off (--)
0 - 6
The list of recent
alarms / errors.
. The
on the front
.