Parkside Performance PWSAP 20-Li E6 Traduccion Del Manual De Instrucciones Originale página 40

GB MT
d) Grinders may only be used for
the recommended attachment
options. For example: never
grind with the side surface of a
cutting disc. Cutting discs are for cut-
ting material using the edge of the disc.
Pushing sideways on these grinders can
break them.
e) Always use undamaged clamping
flanges of the correct size and
shape for the grinding disc you
selected.­Suitable­flanges­support­the­
grinding disc and thus reduce the danger
of the grinding disc breaking. Flanges for
cutting discs can be distinguished from
flanges­for­other­grinding­discs.
f) Do not use worn grinding discs
for larger electric tools. Grinding
discs for larger electric tools are not
set up for the higher rotation speeds of
smaller electric tools and can break.
g)­ When using wheels for a dual
purpose, always use the appro-
priate guard cover for the appli-
cation being performed. Failure
to­use­the­correct­guard­cover­can­miss­
the desired shielding and result in seri-
ous injury.
Other special safety
instructions for cutting
grinding
a) Avoid blocking the cutting disc
or pressing down too hard. Do
not make any excessively deep
cuts.­Overloading­the­cutting­disc­
increases wear and its tendency to tilt
or block and, with that, to kickback or
break the grinder.
b) Avoid the area in front of and
behind the rotating cutting disc.
40
When­you­move­the­cutting­disc­by­itself­
in­the­workpiece,­in­the­event­that­the­
electric tool kicks back with the rotating
disc, it can spin directly towards you.
c) If the cutting disc jams, or you
interrupt your work, switch the
device off and hold it until the
disc has come to a full stop. ne-
ver try to pull the cutting disc
out of the cut while it is still run-
ning, because it can kick back.
Identify and correct the cause of the
jamming.
d) Do not switch the electric tool
on again as long as it is in the
workpiece. Allow the cutting disc
to first reach its full rotational
speed before you carefully resu-
me with the cutting. Otherwise, the
disc may catch, spring away from the
workpiece or cause a kickback.
e) Support plates or workpieces to
reduce the risk of kickback from
a jammed cutting disc. Large
workpieces may bend under
their own weight.­The­workpiece­
must be supported on both sides of the
disc, near the cutting disc as well as
also at the edge.
f) Be particularly careful for po-
cket cuts in existing walls or
other areas where you cannot
see what is there.­The­cutting­disc­
may cause a kickback when it cuts into
gas or water lines, electrical lines or
other hidden objects.
g)­ Do not make curve cuts.Over-
loading­the­cut-off­wheel­increases­its­
stress and susceptibility to jamming or
blocking, thus increasing the possibility
of­kickback­or­abrasive­wheel­breaka-
ge, which can lead to serious injury.