Parkside Performance PWSAP 20-Li E6 Traduccion Del Manual De Instrucciones Originale página 46

GB MT
-­ ­ E nsure­that­the­tool­dimensions­match­
those­of­the­device.
-­ ­ O nly­use­flawless­discs­(ringing­test:­
when you strike the grinding disc with
a plastic hammer, it results in a clear
sound).­
-­ Never­re-drill­a­locating­hole­which­is­
too small for the cutting/grinding disc to
make it larger.
-­ Never­use­separate­bushings­or­adap-
ters in order to make cutting/grinding
discs­with­a­hole­that­is­too­large­fit­the­
device.
-­ ­ D o­not­use­any­saw­blades.
-­ Only­the­supplied­quick-change­nut­and­
mounting­flange­may­be­used­to­clamp­
the grinding tools.
-­ ­ R eassemble­the­device­completely­after­
replacing the tool.
­ Switch­off­the­device­and­remove­
the­battery­from­the­device.­Allow­
the­device­to­cool­down.
­ Wear­protective­gloves­when­chan-
ging­the­tool­so­as­to­avoid­injuries­
from cuts.
­ The­quick-change­nut­(20)­must­not­
be­tightened­too­much­to­avoid­
breaking the washer and nut.
Inserting/removing the
rechargeable battery
1.­ To­insert­the­rechargeable­battery­(17)­
into­the­device,­push­the­battery­along­
the­guides­into­the­device.­You­will­
hear it click into place.
2.­ To­remove­the­battery­(17)­from­the­
device,­press­the­release­button­(16)­on­
the battery and pull the battery out.
46
Checking the charge level of
the rechargeable battery
LED lights on the charge level
indicator:
Red-amber-green => battery fully charged
Red-amber => battery approx. half charged
Red => battery needs to be charged
Checking the charge status on the
tool:
The­charge­level­indicator­(8)­on­the­unit­
shows­the­charge­level­of­the­battery­by­
illuminating­the­corresponding­LED­lights­
during operation.
Checking the charge status on the
battery:
The­battery­charge­level­indicator­on­the­
battery­(17)­indicates­the­charge­level­of­
the battery.
The­charge­level­of­the­battery­is­indicated­
by­illumination­of­the­corresponding­LED­
light.­Press­the­button­for­the­charge­level­
indicator on the battery.
Charging the battery
If warm, allow the battery to cool be-
fore charging.
Charge the battery (17)­when­only­
the­red­LED­of­the­charge­level­indi-
cator­on­the­device­or­battery­is­still­lit.
1.­ If­necessary,­remove­the­battery­(17)
from the tool.
2. Slide the battery (17) into the charging
slot of the charger (18).
3. Plug the charger (18) into a power out-
let.
4. Once charging is complete, disconnect