Parkside Performance PWSAP 20-Li E6 Traduccion Del Manual De Instrucciones Originale página 45

If the rotary direction is indi-
cated on your disc, ensure
that it corresponds to the rotary di-
rection of the angle grinder when
mounting. This is indicated on the
device below the spindle stop but-
ton (9) ( ).
­ Ensure­that­the­flange­(
placed­on­the­device­in­such­a­way­
that­the­recesses­in­the­flange­grip­into­the­
edge­of­the­device.­The­mounting­spindle­
(22)­must­turn­simultaneously­when­you­
turn­the­flange.­
5.­ Place­the­quick-change­nut­(20)­on­the­
uptake­spindle­(22).
6.­ Press­the­spindle­lock­button­(5)­and­
turn­the­uptake­spindle­(22)­until­the­
spindle lock button holds the uptake
spindle­in­a­fixed­position.­
7.­ Fix­the­quick-change­nut­(20)­by­hand­
or­with­the­chuck­key­(13).You­can­now­
release­the­spindle­lock­button­(5).
Installing/changing the
wire brush
1.­ Press­the­spindle­stop­button­(5).
2.­ Turn­the­mounting­spindle­(22)­until­the­
spindle stop button holds the mounting
spindle­in­a­fixed­position.­Keep­the­
spindle­stop­button­(5)­depressed.
3. Release the wire brush with a combina-
tion wrench (not included in the scope
of­delivery).­You­can­now­release­the­
spindle­stop­button­(5).
4. Place the desired wire brush onto the
mounting spindle.
5.­ Press­the­spindle­stop­button­(5)­and­
rotate the wire brush on the mounting
spindle­(22).­Tighten­the­wire­brush­
using a combination wrench. You can
now­release­the­spindle­stop­button­(5).
Operation
-­ Remove­the­battery­before­carrying­out­
any­work­on­the­device.
-­ Only­use­cutting/grinding­discs­and­ac-
cessories recommended by the manufac-
21)­is­ turer. Using other attachment tools and
other accessories can represent a risk of
injury for you.
-­ Only­use­accessory­parts­which­bear­
information about the manufacturer, type
of connection, dimension and permitted
number­of­revolutions.
-­ Only­use­accessory­parts­where­the­
printed rotational speed is at least as
high­as­what­has­been­specified­on­the­
name­plate­of­the­device.
-­ Do­not­use­any­broken,­cracked­or­
otherwise damaged diamond cutting/
grinding discs.
-­ Never­operate­the­device­without­protec-
tive­equipment.
- Support the plates or workpieces in or-
der to reduce the risk of kickback from a
jammed cutting disc. Large workpieces
may­bend­under­their­own­weight.­The­
workpiece must be supported on both si-
des of the disc, not only near the cutting
disc, but also at the edge.
-­ ­ N ever­operate­the­device­without­protec-
tive­equipment.
-­ ­ E nsure­that­the­rotation­speed­stated­on­
the tool is the same or higher than the
nominal­idle­speed­of­the­device.
Caution! Risk of injury!
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Information
on replacement:
GB MT
45