Publicidad
Idiomas disponibles
Idiomas disponibles
VARIABLE
SPEED CONTROLLED
TRIGGER
SWITCH
Your tool is equipped
with a variable
speed
trigger switch.
The tool can be turned "ON" or
"OFF" by squeezing
or releasing
the trigger.
The speed can be adjusted
from the minimum
to maximum
nameplate
RPM by the pressure
you apply to the trigger.
Apply more pressure
to increase
the speed and release pressure
to
decrease
speed (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER
LOCK
_
After tool use, lock trigger
in
"OFF" position to help prevent
accidental
starts and accidental
discharge.
Your
tool
is equipped
with
a forward/
reversing lever and trigger lock located above
the trigger
(Fig. 2). This lever was designed
for changing
rotation of the bit, and for locking
the trigger in an "OFF" position.
For forward
rotation,
(with
chuck
pointed
away from you) move the lever to the far left.
For reverse
rotation
move the lever to the far
right. To activate
trigger
lock move
lever to
the center off position.
Do not change direction of
rotation
until
the
tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
m
GEAR SHIFTING
Your tool is equipped
with two separate
gear
ranges,
low gear and high gear.
Low gear
provides
high-torque
and slower
drilling
speeds
for heavy
duty work
or for driving
screws.
High gear provides
faster
speeds
for
drilling
lighter work. To change
speeds
slide
switch, to the high or low position (Fig. 3).
ATTENTION:
If your
tool
appears
to be
running,
but the chuck will not turn, check
to
make sure the gear shifting switch
is pushed
fully into desired setting.
ADJUSTABLE
CLUTCH
Your tool features
21 clutch
settings.
Output
torque
will increase
as the clutch
ring,
is
rotated from 1 to 20. The drill "gLllu"
position
will lock up the clutch
to permit
drilling
and
driving heawduty
work, and also enables
bits
to be changed
quickly
and easily
in the
keyless chuck (Fig. 3).
BRAKE
When
the
trigger
switch
is released
it
activates
the brake to stop the chuck quickly.
GEARSHIFTER--
ADJUSTABLE--
CLUTCH
This
is especially
useful
in the repetitive
driving and removal of screws.
BIT STORAGE
AREA
Your tool is equipped
with a bit and storage
area that is conveniently
located
in the handle
base where it is always handy and unlikely to
get lost or misplaced
(Fig. 1).
-9-
Publicidad
