Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Exdanation of general view
1 Battery cartridge
6 Hook (ML122 only)
2 Set plate
7 Strap (ML122 only)
3 Screw
8
Fluorescent tube
4 Ring
9 Lamp cover
5
Reflector (ML122 only)
10 Connecting ring
11 Switch
12 Cap
13 Metal fitting
14 Hook (ML123 only)
15 Reflector (ML123 only)
SPECIFICATIONS
Model
ML122
ML123
Power source
.............................
D.C. 12 V
/
9.6 V
D.C. 12 V 19.6 V
Fluorescent tube
........................
Compact FL13 W
Compact FL13 W
Dimensions (L x W x H)
............
347 mm x 97 mm x 94 mm
411 mm
x
97 mm x 94 mm
(when the hook is pulled out)
350 mm
x
97 mm x 94 mm
(when the hook is stored)
0.37 kg
Net weight
...................................
0.35 kg
Due to our continuing program of research and development, the specifications herein are subject
to
change
Note: Specifications may differ from country to country.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric
shock, and personal injury, including the following:
without notice.
READ ALL INSTRUCTIONS.
1. Read this instruction manual and the charger instruction manual carefully before use.
2. This tool is not water-proof.
Do
not use it
in
damp or wet locations.
Do
not expose it to rain or snow.
Do
not wash it in water.
3 .
A short-circuit can cause a large current flow, overheating, possible burns and even a breakdown.
(1)
Do
not touch the battery terminals with any conductive materials.
(2) Avoid storing the battery cartridge in a container with any metal objects such as nails, coins, etc.
4. Never expose the battery cartridge to flames, fire or great heat. Breakage may cause release of
injurious material.
5.
Do
not disassemble the charger or battery Cartridge; take it to a qualified serviceman when service
or repair is required. Incorrect reassembly may result
in
a risk of electric shock or fire.
6. When the tool is not in use, always switch off and remove the battery cartridge from the tool.
7.
Do
not give the tool a shock by dropping, striking, etc.
8. Do not expose the light to eyes continuously. It may hurt them.
9. Do not cover or clog the lit tool with cloth or carton, etc. It may create
a
risk of fire.
10. if you notice that the tool is hot or In abnormal condition, consult your nearest Maklta Service
Center or dealer.
When the switch is turned "ON", the handle of the tool may become slightly hot, even if the
fluorescent tube is not instailed or is not lighted. This is a normal condition and does not indicate
problem.
11. If any problem develops, consult your nearest Makita Service Center or dealer. To maintain product
safety and reliability, repairs, maintenance or adjustment should be carried out by Makita
Authorized Service Center.
12. Switch off the light immedlately when the lamp gets dark in use. if you leave the lamp switched on,
the battery cartridge capacity may decrease.
SAVE THESE INSTRUCTIONS.
4
Publicidad
