Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing fluorescent tube
(Fig. 3 & 4)
CAUTION:
1,
Do
not give the fluorescent tube a shock or mar it. It may result in a risk of breakage of the glass and a
serious personal injury.
2.
Do
not touch the fluorescent tube which is hot in use or immediately after putting out light. You may get
burnt.
3. Always be sure that the battery cartridge is removed before replacing the fluorescent tube or maintenance.
Remove the connecting ring and pull the lamp cover straight out to remove it. Then remove the cap and pull
the tube to replace the tube.
To install the lamp cover, place the cap on the tube. Then insert the lamp cover so that the protrusion on the
tool fits into the groove on the lamp cover. And insert the connecting ring so that the pin on the connecting ring
fits into the groove on the lamp cover.
Strap and hook
Install the strap on the tool.
(Flg.
5)
When storing the tool, hang the metal fitting of the strap on the ring of the
tool.
(Fig. 6)
CAUTION :
Do
not shake the tool when the hook is pulled out. The hook can catch something accidentally.
Do not use the hook except when you hang the tool. This may result in a risk of breakage of the tool.
The hook can be turned, slid and stored around the lamp cover. (Fig. 7)
The hook also can be removed when you do not use it.
To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita
Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use
of
any other accessories or attachments might present a risk of injury to persons. The accessories or
attachments should be used only in the proper and intended manner.
Fluorescent tube
Publicidad
