Scheppach DP16VLS Traduccion Del Manual De Instrucciones Originale página 23

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
we hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 570,813/ VDE0113.
We recommend:
Read through the complete text in the operating instructions
before installing and commissioning the device.
The operating instructions are intended to help the user
to become familiar with the machine and take advantage
of its application possibilities in accordance with the rec-
ommendations.
The operating instructions contain important information
on how to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, reduce
downtimes and how to increase reliability and service life
of the machine.
In addition to the safety regulations in the operating in-
structions, you have to meet the applicable regulations
that apply for the operation of the machine in your country.
Keep the operating instructions package with the machine
at all times and store it in a plastic cover to protect it from
dirt and moisture. Read the instruction manual each time
before operating the machine and carefully follow its in-
formation.
The machine can only be operated by persons who were
instructed concerning the operation of the machine and who
are informed about the associated dangers. The minimum
age requirement must be complied with.
In addition to the safety instructions contained in this op-
erating manual and the specific regulations of your coun-
try, the technical rules generally accepted for the oper-
ation of machines of the same type must be observed.
We accept no liability for damage or accidents which arise
due to non-observance of these instructions and the safe-
ty information.
2. Device description
1. Base plate
2. Pillar
3. Drilling table
4. Machine head
5. Drill chuck
6. Grips
7. Drill chuck protection
8. Depth stop
9. Motor
10. On-Off switch
11. Belt protective hood
12. Counternuts for belt tension
13. Laser module
13.1 Laser on/off switch
13.2 Battery compartment cover
14. Vice
A Hexagonal screw
B 4 mm Allen key
C Vice fastening screws
D Drill chuck key
E Table locking
F Allen screws
G Nut fastening, depth stop
H Philips screw, chuck guard
I Hole housing, depth stop
J Nut, depth stop
K Pointer, depth stop
L Groove
M Spring cap
N Inner nut
O Outer nut
P Hub
S Table locking
T Laser set screw
U Laser countersunk screw
V Belt guard screw
W Laser locknut
www.scheppach.com GB | 23