Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
WARNING! Danger of exploding or burst-
ing open of non-rechargeable batteries! De-
pending on the model, non-rechargeable batter-
ies can explode or burst open when charged. Es-
caping electrolyte fluid can get onto the skin and
into the eyes, causing serious acid burns.
■
Do not charge any non-rechargeable batter-
ies.
■
If you come into contact with electrolyte fluid,
wash the contact point with copious soap and
water. If electrolyte fluid gets into the eyes,
rinse the eyes immediately with copious
amounts of water and then consult a doctor.
3.2
Possible foreseeable misuse
DANGER! Danger of explosion and fire!
Persons can be severely or fatally injured if the
appliance causes an explosion because it was
used in a potentially explosive environment.
■
Do not use the appliance in environments
where there is a potential risk of explosion
and/or fire.
3.3
Product overview
No.
Component
1
LED for displaying the operating states
(left battery compartment)
2
LED for displaying the operating states
(right battery compartment)
3
LED wireless LAN operating state
4
ECO button for slow charging
5
Handle
6
Left and right battery compartment
7
Mains cable with power plug
8
Attachment holes for wall mounting
(spacing: 132 mm)
4 START-UP
IMPORTANT! Danger of material damage
due to incorrect mains voltage! Incorrect mains
voltage can damage the charging unit and the re-
chargeable battery.
■
Before connecting the charging unit, make
sure that the mains voltage matches the volt-
age stated in the "Technical data".
443551_a
4.1
Setting up the charger
IMPORTANT! Danger of material damage
due to overheating! Poor ventilation of the
charging unit during the charging process can
damage the charging unit and the rechargeable
battery.
■
Always place the charging unit on a well ven-
tilated and non-inflammable surface.
■
Keep the ventilation slots clear and do not
cover the appliance.
1. Remove the charger from the packaging.
2. Place the charger on a non-inflammable, lev-
el surface at a safe distance from other ob-
jects.
3. Insert the mains plug. The charger is ready
for operation.
4.2
Mounting the charger on the wall
The charger has two attachment holes (01/7)
132 mm apart on its underside. These allow the
charger to be attached to a vertical surface, e.g.
wall or board.
1. Screw two round-head screws into the sur-
face until the screw heads are protruding by
approx. 2 to 3 mm.
2. Hook the charger over the screw heads.
3. Check that the charger is securely supported.
If not, remove the charger again and screw
the screws slightly further into the surface.
5 OPERATION
5.1
Charging the rechargeable battery
You can choose to charge one battery or two bat-
teries simultaneously with the charger.
NOTE Fully charge the rechargeable battery
before using it for the first time. The rechargeable
battery can be charged in any charge status. In-
terrupting charging does not damage the re-
chargeable battery.
CAUTION! Danger of fire during
charging! Due to heating of the charger, there is
a danger of fire if it is placed on an inflammable
surface and is not adequately ventilated.
■
Always use the charger on a non-inflamma-
ble surface or in a non-combustible environ-
ment.
■
If available: Keep the ventilation slots free.
1. Insert the mains plug of the charger into the
power socket.
15
Publicidad
