RIDGID R4221 Manual Del Operador página 23

ASSEMBLY
 Remove the bevel lock dust cover.
 Move the bevel lock lever to the unlocked (detent disen-
gaged) position.
 Set the bevel at any angle that allows access to the 4
screws on the back of the bevel lock bracket.
 Move the bevel lock lever to the locked position.
 Using a 4 mm hex wrench, loosen the 4 screws that hold
the bevel detent plate in place. Do not remove the screws.
 Move the bevel lock lever to the unlocked (detent disen-
gaged) position.
 Set the bevel angle at 0°.
 Move the bevel lock to the unlocked (detent engaged)
position.
 Check the 0° angle using a combination square.
 If adjustment is needed, use a 4 mm hex key to turn the
micro adjust screw on the front of the bevel lock bracket
to adjust the saw to the 0° bevel angle.
 Move the bevel lock lever to the locked position.
 Tighten the 2 outermost screws that retain the bevel
detent plate.
 Move the bevel lock lever to the unlocked (detent disen-
gaged) position.
 Set the bevel at 45°. Move the bevel lock lever to the
locked position.
 Tighten the remaining 2 screws that retain the bevel
detent plate.
 Replace the bevel lock dust cover and tighten the screws
securely.
SCREWS
BACK OF BEVEL LOCK BRACKET
SCREWS
FRONT OF BEVEL LOCK BRACKET
MICRO ADJUST
SCREW
23 - English
BEVEL BYPASS
LEVER
BEVEL LOCK
DUST COVER
BEVEL LOCK
LEVER
Fig. 29
SCREWS
BEVEL DETENT
PLATE
Fig. 30