Descargar Imprimir esta página

Modular EM70/40 FRE8+8 Instalación, Uso, Mantenimiento página 18

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

The energy regulator control knob has the following
positions:
PILOT IGNITION
-
Turn the knob to the chosen temperature setting for
cooking.
-
Press and turn knob to "pilot on".
-
Press the knob fully down to activate the electronic
ignition and light the pilot burner.
-
Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
-
The pilot flame can be seen by opening the door.
-
The pilot light can be lit by bringing an open flame up
to the nozzle.
MAIN BURNER IGNITION
-
Turn the knob to the chosen temperature setting for
cooking.
TURNING OFF
-
To switch the main burner off, turn the knob to
position "pilot on".
-
To switch off the pilot flame, press and turn the knob
to position "Off".
-
Turn the energy regulator knob to position "0"
ELECTRIC FRYERS
The energy regulator control knob has the following
positions:
OFF
COOKING TEMPERATURES
SWITCHING ON
-
Turn the thermostat knob to the chosen temperature
setting for cooking.
-
The yellow indicator light switches on.
-
The yellow indicator light switches off when the oven
reaches the set temperature.
OFF
COOKING TEMPERATURES
TURNING OFF
-
Turn the thermostat knob to position " 0 ".
-
The yellow indicator light switches off.
12. PROLONGED DISUSE
Before any prolonged disuse of the appliance,
proceed as follows:
-
Clean the appliance thoroughly.
-
Rub stainless steel surfaces with a cloth soaked in
vaseline oil to create a protective film.
-
Close cocks or main switches ahead of the
appliances.
-
Leave pot lids open.
Following prolonged disuse, proceed as follows:
-
Inspect the appliance thoroughly before using it
again.
-
Allow electric appliances to operate at the lowest
temperature for at least 60 minutes.
INSTRUCTIONS FOR CLEANING
IV.
13. REMINDERS FOR CLEANING
READ THIS MANUAL CAREFULLY. IT
PROVIDES
INFORMATION
INSTALLATION,
MAINTENANCE OF THE APPLIANCE.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR
INJURY RESULTING FROM FAILURE
TO OBSERVING THE FOLLOWING
RULES.
DISCONNECT
ELECTRIC SUPPLY, IF PRESENT,
BEFORE
OPERATION.
-
Clean the satin finish stainless steel exterior surfaces,
the cooking wells and the surface of the hotplates
every day.
-
At least twice a year, have an authorized technician
clean the internal parts of the appliance.
18
IMPORTANT
FOR
SAFE
USE
AND
THE
APPLIANCE
CARRYING
OUT
ANY

Publicidad

loading