Dirt cup
kYour cleaner
is equipped
with
a self-cleaning
HEPA filter.
P This filter
is NOT removable.
While the cleaner is in operation, the pre-filter screen (A) will stop larger
debris from entering the HEPAfilter chamber. This larger debris will be
seen collecting in the larger side of the dirt cup (B). The HEPAfilter will
collect fine particles that have passedthrough the pre-filter screen. The
HEPA filter cleans itself while rotating, depositing fine debris in the smaller
side of the dirt cup (C).
The 'Z' cleaner wBI continue to perform at maximum cleaning levels if the
pre-filter screen is cleaned when the dirt cup is emptied (see Fig. 19).
If you notice that the filter is rotating slower than normal, not rotating, or
the filter light comes on, refer to the Troubleshooting
section.
When
to empty
It is recommended
that the dirt cup be emptied
before the dirt reaches the
top of the dirt cup or after every use if you prefer.
How to empty
Disconnect
cleaner
from electrical
outlet.
Do not use cleaner
without
dirt
cup or filters in place.
Unfold the cleaner
to the upright
position
before
removing
dirt cup.
To remove cup, pull handle to unlatch (:up. Pull cup straight out.
Q
urn the dirt cup upside down over a trash container.
Pull tab to
release door (D). Empty dirt cup.
CLEAN THE PRE-FJLTERSCREEN (E) using the dusting
brush tool.
\
//
Push the cup straight into the dirt cup cavity, push up sJightly and
pivot the handle back to lock the dirt cup in place.