Descargar Imprimir esta página

Hoover U9125900 Manual Del Usuario página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

Proper u seandcareof yourcleaner w ill ensure c ontinued cleaning
effectiveness.
HEPA filter
The HEPA filter equipped
with your cleaner
is self-cleaning,
and
under normal
cleaning
conditions,
should
not need to be replaced.
If you feel that this filter needs replacement,
take your cleaner to an
Authorized
Hoover
Sales and Service Center.
Final filter
Disconnect cleaner from electrical outlet. Do not use cleaner without
dirt cup or filters in place.
QThe
final filter, located on the opposite side of the cleaner
from the dirt cup, is removable and can be washed in cold
water and a mild detergent. Rinse and let filter air dry completely
before repositioning.
To remove this filter, rotate filter cover counterclockwise.
Remove the filter, wash, air dry and return to the filter cavity.
Replace the filter cover by aligning
the tabs and rotating clockwise
back into position.
Should you want to replace this filter, ask for HOOVER
part No.
38762013.
Disconnect
cleaner from electrical
outlet.
Low suction or pick up may be due to a blockage in the system. Refer to
the following stepsto check for blockages continuing with each step
until the blockage is found:
Turn cleaner OFF and disconnect from electrical outlet.
1. Check fullness of dirt cup container. Empty cup if full.
(See Figs. 17 & 18)
2. Clean pre-fiJter screen using dusting brush tool (see Fig. 19).
Check agitator
brush roll
3. Turn cleaner OFF and disconnect
from electrical
outlet.
4. Turn cleaner over an(] clear blockage from brush roll. Do not
attempt to remove the agitator brush roll,
Return cleaner to operating position. Plug in, turn cleaner back ON and
continue cleaning.

Publicidad

loading

Este manual también es adecuado para:

U9125950