Use
the chart
below
as a guide
to the indicator
lights
on the
control
panel.
Agitator sta[I light (C) ON; See Manua[ light (A) ON;
Power light blinking. Cleaner wii[ not run.
Obstruction
in agitator.
_/ Turn the cleaner OFF and unplug. Turn cleaner over. Check for obstruction and remove.
Suction motor light (D) ON; See Manua[ light (A) ON;
Suction motor has overheated.
Power light blinking. Cleaner wii[ not run.
,/ Check dirt clip. Empty if full.
V" Refer to "Clearing
_1_ ckages
on pages
12 and 1.3. Clear any blockages.
Height adiustment
light (LOW, MED or HIGH)
continuously
blinking.
,/ Check final filten Clean if dirty.
,/ Turn the cleaner OFF and unplug.
Wait 15 minutes; plug cleaner back in
and turn ON.
Nozzle is unable to move to
selected setling. (NOTE: Light
will blink, then stop as it transi-
tions between carpet heights.)
The cleaner
can still be used.
_& Rirn cleaner
OFF, then ON. If I_ht
continues
to blink, take cleaner
to a HOOVER
.Sales
Service Center for service.
Filter light (B) ON; See Manual light (A) ON. HEPA
fi]ter not turning
or turning
slower than norma].
Filter not rotating; jam in filter
drive.
,/ Place cleaner" in the upright
position
with hose end connected
to the wand. Turn cleaner"
OFF, empty dirt cup and ctdan pre-filter
screen. Turn back ON. If filter" now turns, allow
it
to run for one minute.
Atter one minute,
turn cleaner
OFF and empty dirt cup. Continue
cleaning.
_/ If the filter is still not turning,
take to a HOOVER
.Sales & .Service Center for service.
Power light blinking; See Manual light (A) ON.
Cleaner will not run.
Internal system problem.
_/ Rim the cleaner
OFF, then back ON. If the lights remain the same, service is needed.
T_/<eto a HOOVER Sales & Service C_nte_
Power light blinking; See Manual light (A) blinkir_.
Cleaner will not run.
Internal system problem.
¢" Rn'n the cleaner
OFF, then back ON. If the lights remain the same, service is needed.
Take to a HOOVER Sales & Service Center.