Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE PRODUCT
SAFETY TETHER AND EMERGENCY STOP
The equipment comes with a "safety tether" (A). The safety tether must
be attached to the console for the equipment to run. It is designed to
attach to your clothing so that if you leave or fall from the equipment it
will stop automatically, helping prevent injury.
Before beginning a workout session, ensure that the safety tether is
properly placed onto the console and that the clip is securely attached
to your clothing.
NOTE: If the equipment is on, but the safety tether
is not attached, "E07" shows on the display and the
equipment cannot be started.
START UP
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
ATTENTION: Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the product is properly grounded. Do not modify the plug provided with the product – if it will not
fit the outlet, have a proper outlet installed by a qualified electrician. This product is for use on a
nominal 220-volt circuit and has a grounding plug that looks like the plug illustrated in sketch A in
following figure. Make that the product is connected to an outlet having the same configuration
as the plug. No adapter should be used with this product.
The equipment features a computerized display that provides you with controls for operating the unit as well as
workout information, such as duration, speed, distance travelled etc.
To use the equipment:
1.
Plug the equipment into the electrical supply.
2.
Place the power switch (B), located at the front of the unit, in the "ON" ("I") position.
3.
Attach the safety tether to the safety tether location on the console.
4.
Operate the equipment as desired.
ATTENTION: Always stand on the side rails when starting the equipment. Never stand on the belt
then start the machine.
62
49
Publicidad
