Dometic COOLAIR RTX1000 Instrucciones De Montaje página 11

CoolAir
7.7 Fitting the unit in the roof hatch
!
CAUTION! Risk of injury
Only install the unit in support of e. g. second person, crane, working platform.
The work safety must be guaranteed at all times.
➤ Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig. c).
I
NOTE
Once the unit is in position on the vehicle roof, the seal should make contact all
the way round. Only then can a reliable seal be achieved.
A
NOTICE! Damage hazard
Do not exceed the specified tightening torque under any circumstances. That
is the only way to ensure that the threaded plugs are not pulled out.
➤ Fix the parking cooler in place as illustrated (fig. c).
7.8 Routing the electrical power supply leads
D
DANGER! Explosion hazard
For EX/III and FL vehicles (according to ADR guideline), a battery master switch
must be installed.
!
WARNING! Risk of injury
• The electrical connections may only be made by competent technical staff
with the appropriate specialist knowledge.
• Before carrying out any work on electrically operated components, make
sure that they are disconnected from the power supply.
A
NOTICE! Damage hazard
• The connection to the vehicle's electrical system should be protected by a
40 A fuse for the power supply and a 2 A fuse for the voltage monitor.
• The battery must be capable of supplying the required current and voltage
(chapter "Technical data" on page 16).
• Route the power supply lead stressless and secure it with cable binders in
appropriate intervals.
Connect the unit directly to the main power distribution box.
Ask your vehicle manufacturer for the specifications of the main power
distribution box.
EN
Installation
11