Publicidad
Idiomas disponibles
Idiomas disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
For models equipped with Leveling Leg
only (no leveling device):
EI viake sure the four leveling legs (front and rear) are
setup higher than the height of the cabinet.
8.6
Nee
Install the anti-tip bracket at
this point before placing the range at its final
position. Follow the installation instructions on
page 11 or on the anti-tip bracket template supplied
with the range.
Et.
provide an optimum installation, the top surface
of the countertop must be level and flat (lie on the
same plane) around the 3 sides that are adjacent
to range cooktop. Proper adjustments to make
the top flat should be made or gaps between the
countertop and the range cooktop may occur.
ACAUTION
To reduce the risk of damaging your
appliance, do not handle or manipulate it by the
ceramic glass. Manipulate with care.
ED position range in front of the cabinet opening.
ERM
viake sure that the glass which overhangs the
countertop clears the countertop. If necessary, raise
the unit by lowering the leveling legs.
ERE
Level the range. The floor where the range is to be
installed must be level. Follow the instructions under
"Leveling the Range-Models Equipped with Leveling
Legs".
ERY slide the range into the cutout opening.
IMPORTANT
If Accessories Needed
installation With Backguard
A backguard kit can be ordered through a Sears
Service Center. The cutout depth (2134" (55,2cm) Min.,
22'/s" (56,2cm) Max.) needs to be increased to 24"
(61cm) when installing a backguard
installation With End Panel
An end panel kit can be ordered through a Sears
Service Center.
installation With Side Panel
A side panels kit can be ordered through a Sears
Service Center. Install cabinet doors 31" (78,7cm) min.
apart so as not to interfere with range door opening.
EH Leveling the Range
EX] Models Equipped with Leveling Device
Level the range after installation in the cutout opening.
1. Open the range drawer. The leveling screws control
the height of the rear leg.
2. Adjust the appliance legs as follows until the underside
of the cooktop (or cooktop glass) surface is sitting
level on the countertop (Figure 7).
a. To adjust the front legs, use a wrench on the
leg base and turn counterclockwise to lower or
clockwise to raise the range.
b. To adjust the rear legs, use a ratchet or a nut driver
and turn the leveling screws counterclockwise to
lower or clockwise to raise the range.
3. Check if the range is level by installing an oven rack in
the center of the oven and placing a level on the rack
(Figure 8).
4. Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5. If the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
Rear Levelin
Device
Use this Screw
to Adjust Rear Leveling
_
Device Height
.
Joins
Figure 7
EX] Models Equipped with Leveling Legs
Level the range and set cooktop height before
installation in the cut-out opening.
1.
Install an oven rack in the center of the oven.
2.
Place a level on the rack (see Figure 8). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 17).
3.
Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness.
Publicidad
