Publicidad
Idiomas disponibles
Idiomas disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
Et § Decorative Rear Trim Installation
(if required)
1.
Disconnect the power from the range.
2.
Make sure the range is leveled.
3.
Pull range toward you.
4.
Measure the distance between the floor and the
surface underneath the cooktop frame.
5.
Mark that distance on the wall where the decorative
trim will be installed.
Draw a line.
Place the top of the decorative trim under that line.
8.
Using the screws provided fix the decorative trim into
the wall.
9.
Slide the range back into position as far as it will go
and reconnect the power source.
_
a
_- Distance
between the
floor and
lo
the surface
underneath
the cooktop
frame.
NN
EER Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Remove all packaging from the oven before testing.
EEA] install Burner Bases and Burner Caps
This range is equipped with sealed burners
as shown (see Figure 10).
aunecap
——
a. Unpack burner bases and
om
burner caps.
!
b. Place burner bases over
Se
each gas opening.
ah
c. Make sure the burner
is properly aligned and
leveled. Place burner caps
over appropriate burner
bases.
NOTE: There are no burner
adjustments necessary on this
range.
")
Electrode ">-~. _—_
Figure 10
EEF] Turn on Electrical Power and Open
Main Shutoff Gas Valve
HE] Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power. To check for proper lighting:
a. Push in and turn a surface burner knob to the LITE
position. You will hear the igniter sparking.
b. The surface burner should light when qas is available
to the top burner. Each burner should light within
four (4) seconds after air has been purged from supply
lines. Visually check that burner has lit.
c. Once the burner lights, the control knob should be
rotated out of the LITE position.
There are separate ignition devices for each burner. Try
each knob separately until all burner valves have been
checked.
Adjust the "LOW" Setting of Surface
Burner Valves (see Figure 11)
a. Push in and turn each control to LITE until burner ignites.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, readjust valve as follows:
Reset control to OFF. Remove the surface burner
control knob, insert a thin-bladed screw driver into the
hollow valve stem and engage the slotted screw inside.
Flame size can be increased or decreased with the
turn of the screw. Adjust flame until you can quickly
turn knob from
g
(C
j
LITE to LOWEST
POSITION without
extinguishing the
flame. Flame
should be as small
as possible
without
going out.
Publicidad
