Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8
1.
Attach the end with stopper ball of Cable for Lower Pull Bar (65) to the open bracket of Leg Curl (7), around the
under side of Pulley (48), tighten the Pulley(48) with the bracket by X1 Hex Head Bolt (28) through X2 Plastic
Bushing (46) (each side), X2 Falt washer(24) (each side) and X1 Nylon Nut (38).
2.
Draw the Cable (65) through the opening space on the lower part of Upright Support Tube (2), around the
Pulley (48) from under side then attach the Pulley (48) to Bracket C on the Base Frame (1), tighten by X1 Hex
Head Bolt (26) and X1 Nylon Nut (38).
3.
Draw the Cable (65) upward and around the upper side of Pulley (48). Attach the Pulley (48) to the under side of
the Bracket for Pulley (16), tighten by X1 Hex Head Bolt (26) and X1 Nylon Nut (38).
4.
Draw the Cable (65) downward and around the under side of Pulley (48). Attach the Pulley (48) to bracket D
on the Base Frame (1) and tighten by X1 Hex Head Bolt (26) and X1 Nylon Nut (38).
5.
Draw the Cable (65) upward and around the upper side of Pulley (48). Attach the Pulley (48) to the under side of
Bracket for Pulley B (20) set and tighten by X1 Hex Head Bolt (26) and X1 Nylon Nut (38).
6.
Draw the Cable (65) downward and connect with bracket E on Base Frame (1) by Chain 7 Links (59) and X1
Hook (61). Note: Adjust the Cable (65) to be tighten enough and lock on certain position of Chain (59) by
Hook (61).
7.
Attach the Lower Pull Bar (14) to the front end of Cable (65), connecting by Chain 6 Links (60).
MULTY-STATION HOME GYM MUB3002P
35
EN
Publicidad
